The quote uses our adjustable ShelfTrack system. This fixing system is heavier duty than our standard fixed mount system and provides flexibility in the future to amend the design as you see necessary. If you would like a quotation using our standard fixed mount system, then do let me know and I’ll happily provide a quote.
Along with our ShelfTrack system, we have also used our low profile shelving in 30.5cm deep. This shelving is also available in 40.6cm deep so if you would like us to requote in the deeper size then just let us know.
Back wall (5000mm wide). Along this wall we have only used the section as indicated in your photograph.
In this design we have allowed space for hanging garments on the left hand side, and provided shelving for storing flat and folded items. The shelves are 78cm wide, except for the top shelf which extends a little further to meet the top shelf on the adjacent wall.
We have included our 2.13m/ 84” long (and 1 x 30.5cm/ 12” long to the left side) wall standards, but due to the pipe work you have in situ along the bottom of your wall, you will need to cut these standards with a hacksaw so that they can mount to the wall.
Left hand side wall (920mm wide). Along this wall we have included a two tier hanging section for short items such as blouses, jackets, shirts, trousers, skirts etc.
This section is 920mm wide and here we have used our 1.52m/ 60” long wall standards in order to provide enough space for the shelving, but also avoiding the pipe work.
The dimensions that I have worked to for your enclosure and the width and heights of the all the shelving used. Please be sure to double check that these measurements are all correct, ClosetMaid cannot be held responsible of any mis-measures or incorrect information given during this design process.
It is important to point out that our ClosetMaid shelving must be fixed to walls that are flat across their face, perpendicular to the floor and in good condition.
Please note that as this design is carried out using customer supplied data most lengths of shelving & hang bar will be supplied oversized to accommodate variances in wall dimensions and mis-measures and will require trimming to final size on site by the customer. This can easily be done using a set of boltcutters or a hacksaw. End caps are provided to cover the cut ends of the shelves & hang bars.
Total cost to supply & deliver the parts needed to create this layout (to your address in Chertsey) inc. VAT: £419.94 (£20 delivery charge added at checkout)
Terms & Conditions for design service orders can be found here. Please read carefully.
